Keeping your house at the optimum temperature is essential for saving energy, but it can be challenging if you don’t have a good thermostat. Intelligent thermostats like ecobee take the guesswork out of adjusting your home’s climate because they offer a stable level of heating and cooling and sensors that automatically adjust to changes in your daily routine.

There are a lot of good ecobee thermostats on the market, so it’s tough to know which one is best for you. You can rely on Ecobee to help you pick a model that can bring your house’s temperature anywhere between 58°F and 77°F in your sleep.

thermostat installation services

Why do homeowners need ecobee thermostats?

You may wonder why you need a thermostat if you have an energy-efficient furnace and air conditioner. Well, you may have noticed that the climate in your house doesn’t always match that of the surrounding area. It’s common to have your home be a couple of degrees warmer than the temperature in the neighborhood.

This can lead to the heat or cooling system running longer and wasting more energy than necessary. So, through an ecobee thermostat installation, you can set it, so your house stays at a steady temperature even when the rest of your home’s climate varies. The same is valid for heating and cooling. Homeowners often tend to leave their heater running whenever it gets cold outside, which means more energy is heating their homes than necessary. This can be especially problematic for those in cold climates.

How do you know when you need an ecobee thermostat?

If your climate is too warm or cool, your furnace and air conditioner are likely running longer than needed. If you have a central air system, you may notice that the area of your home protected by the air conditioner is colder than the rest. This is because the thermostat that controls your central heating and cooling system is likely located in another area of your house where it tends to stay warmer.

What do you need to know about installing an ecobee thermostat?

An ecobee thermostat will work with most heating and cooling systems, but it can be tricky to install. Make sure you have the right tools before you start, like a screwdriver and wire strippers, as well as some heat-shrink tubing. You will also need to be comfortable with basic wiring and electrical tasks. It’s not that bad, though. You must run the wires from your old thermostat to the new one. These wires should connect to the C and W terminals on your thermostat.